But, they are all on sub amps. Post Number: Registered: Feb But the problem is i cant get the bass and treble to the desired levels. I use graphic EQ then Wave hammer and then normalize. Normalizing makes the bass go down or clips the signal. What should i do. Here, an electronic crossover is used to high-pass the tweeter Hz , band-pass the midrange 80 Hz , and low-pass the subwoofers 80 Hz. Slope can be either 12 dB or 24 dB. This system uses a 3-way active front stage with a pair of tweeters; it has small midrange speakers and bigger woofers.
The front stage created here is more even and efficient in sound reproduction than the 2-way component set. Here are the recommended crossover settings for this system:. Other systems may have rear speakers passive in addition to the Front 2-Way Components active and subwoofer s. The rear speakers will need a High-Pass Filter and two channels of amplification. If rear speakers passive are added to this system, the settings will change a little bit.
Other settings remain the same. Since rear speakers use a passive crossover here, only 2 channels of passed amplification are required. The understanding of how to set crossover frequency for a car audio system starts with knowing how the audio system is configured. You have to know the kind of front and rear speakers that the system features.
As illustrated above, the type of speakers determines the High-Pass, Band-Pass, Low-Pass filters, as well as the frequency to use. There may be other recommendations that differ from the ones given here, but fine-tuning is the most important thing. You can use these recommendations as a guideline, but the final settings depend on your fine-tuning and the quality of sound you find most impressive.
Share 0. Tweet 0. Pin 0. Listen for smooth transitioning between the subwoofer and the speakers. Set the LPF at Hz. Most amplifiers have a 12 dB crossover slope on the LPF, so if you set the LPF higher, you will get punchy bass and it will hit very hard, but if you keep it at Hz you will get smoother lower more pleasant bass. How do you set a low pass filter? Select [Subwoofer Low Pass Filter]. Select the setting you want. On: Always activates the low-pass filter with a cutoff frequency of Hz.
Off: Does not activate the low-pass filter. When should I use high pass filter? A high-pass filter is used in an audio system to allow high frequencies to get through while filtering or cutting low frequencies. A high-pass filter is used with small speakers to remove bass, for example. How do you set a subsonic and LPF filter? Turn your Subsonic Filter down to 10Hz then slowly turn up the filter frequency until you hear it take effect on your sub bass.
The Subsonic is now correctly set. Turn the Low Pass Filter to the setting that allows for the most accurate sub bass sound for your system. What frequency should a subwoofer be set at?
0コメント