All supported modes are enabled. In the default auto mode, a router first tries to connect using the configured ITU operating mode s. This time can be modified with the dsl sync interval command. If this command fails, the router tries ITU mode again for the allotted number of seconds 2 seconds by default.
The router can be forced to try connecting with ANSI mode first by using the dsl sync mode ansi command. If this also fails, the router tries ITU mode again for 3 seconds or the interval specified by dsl sync interval.
If even that fails, the router repeats the cycle mode, including any modes other than ansi mentioned above. If the router is forced to connect in a mode other than auto, you must use DSL operating-mode with the attribute auto to put the router back to the default auto mode.
The router continues switching between modes, in sequence as described, until the router reaches the showtime state which signifies that the connection attempt is successful and connects, using one of the modes. The following example shows how to configure Annex M operating mode, using the dsl operating-mode command and beginning in interface configuration mode:.
To set the interval of time between ANSI synchronization and ITU sychronization, use the dsl sync interval command in interface configuration mode. This number must be within the range from 2 to seconds. To set a preference for Digital Subscriber Line DSL synchronization mode, use the dsl sync mode command in interface configuration mode.
Tells the router to save the current trained mode and to try that mode during the next synchronization. To associate a quality of service QoS group with a private virtual circuit PVC bundle member, use the qos-group command in PVC bundle member configuration mode. When a range of QoS groups is associated with a PVC bundle, only the starting and ending QoS group numbers need to be listed, separated by a hyphen.
For example, For example: 1, 3, , When a QoS group is associated with a bundle member, use a number from 0 to Table 1 lists the release history for this feature. It is supported on Cisco series routers, Cisco series routers, and Cisco series routers.
Impulse noise protection IMP has been added to this release on Cisco series routers, Cisco series routers, and Cisco series routers. Command or Action.
Router config - if dsl sync interval Router config - if dsl enable - training - log delay 5. Caution Enabling the training log takes 1 MB of memory. We recommend using the training log for debugging purposes only.
Router config - if - atm - bundle selection - method qos group. Router config - if - atm - member qos group 5. Router config - subif bundle cisco. Router config - if - atm - member inarp - vc. Related Topic. The following example shows: To enable the training log, enter the following command in interface configuration mode:.
Unfortunately there isn't unless Fibre is available. I've also dropped you a PM. Message 6 of Community Veteran. Posts: 3, Thanks: Fixes: Message 7 of Rising Star. Posts: 2, Thanks: 8. Fixes: 1. Read the OP's message again Moving to a provider that does offer Annexe M may be an option of course Message 8 of Message 9 of Posts: 26, Quote from: Chris Unfortunately Annex M isn't a product that we're offering our Residential customers at this time, however, this isn't to say that this won't change in the future.
Annex M upload speed is up to 2. It is available on request using the Help Assistant. Message 10 of Annex M is only visible for Business broadband services - it is not available for residential services.
Whilst Annex M can provide a gain in upstream sync speed, this can also have an effect on the downstream sync speed in some cases. Again, this all depends on distance from the telephone exchange and quality of the line. Change password Forgotten username?
Annex M FAQ. What's required for Annex M at your location?
0コメント